C
HAPTER
26
| Access Control Lists
IPv6 ACLs
– 709 –
DEFAULT SETTING
None
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
◆ A port can only be bound to one ACL.
◆ If a port is already bound to an ACL and you bind it to a different ACL,
the switch will replace the old binding with the new one.
◆ IPv6 ACLs can only be applied to ingress packets.
EXAMPLE
Console(config)#int eth 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
RELATED COMMANDS
show ipv6 access-list (708)
Time Range (560)
show ipv6 access-
group
This command shows the ports assigned to IPv6 ACLs.
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show ip access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
RELATED COMMANDS
ipv6 access-group (708)
To Next Page
Loading...
