C
HAPTER
14
| Security Measures
Configuring the Secure Shell
– 304 –
Figure 164: Configuring the SSH Server
GENERATING THE
HOST KEY PAIR
Use the Security > SSH (Configure Host Key - Generate) page to generate
a host public/private key pair used to provide secure communications
between an SSH client and the switch. After generating this key pair, you
must provide the host public key to SSH clients and import the client’s
public key to the switch as described in the section "Importing User Public
Keys" on page 306.
N
OTE
:
A host key pair must be configured on the switch before you can
enable the SSH server. See "Configuring the SSH Server" on page 303.
CLI REFERENCES
â—† "Secure Shell" on page 623
PARAMETERS
These parameters are displayed:
◆ Host-Key Type – The key type used to generate the host key pair
(i.e., public and private keys). (Range: RSA (Version 1), DSA
(Version 2), Both; Default: Both)
The SSH server uses RSA or DSA for key exchange when the client first
establishes a connection with the switch, and then negotiates with the
client to select either DES (56-bit) or 3DES (168-bit) for data
encryption.
N
OTE
:
The switch uses only RSA Version 1 for SSHv1.5 clients and DSA
Version 2 for SSHv2 clients.
◆ Save Host-Key from Memory to Flash – Saves the host key from
RAM (i.e., volatile memory) to flash memory. Otherwise, the host key
pair is stored to RAM by default. Note that you must select this item
prior to generating the host-key pair. (Default: Disabled)
To Next Page
Loading...
Need help?
General