C
HAPTER
27
| Interface Commands
– 732 –
show interfaces
switchport
This command displays the administrative and operational status of the
specified interfaces.
SYNTAX
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
DEFAULT SETTING
Shows all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed.
EXAMPLE
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q-tunnel Status : Disable
802.1Q-tunnel Mode : NORMAL
802.1Q-tunnel TPID : 8100(Hex)
Console#
Table 91: show interfaces switchport - display description
Field Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (page 727).
Multicast
Threshold
Shows if multicast storm suppression is enabled or disabled; if enabled it
also shows the threshold level (page 727).
To Next Page
Loading...
Need help?
General