Edge-Core ES3510MA-DC - Figure 43: Configuring the LACP Aggregator Admin Key

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 149 –
other switches during LAG negotiations. (Range: 0-65535;
Default: 32768)
System priority is combined with the switch’s MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
◆ Port Priority – If a link goes down, LACP port priority is used to select
a backup link. (Range: 0-65535; Default: 32768)
N OTE : Configuring LACP settings for a port only applies to its administrative
state, not its operational state, and will only take effect the next time an
aggregate link is established with that port.
N OTE : Configuring the port partner sets the remote side of an aggregate
link; i.e., the ports on the attached device. The command attributes have
the same meaning as those used for the port actor.
WEB INTERFACE
To configure the admin key for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregator from the Step list.
3. Set the Admin Key for the required LACP group.
4. Click Apply.
Figure 43: Configuring the LACP Aggregator Admin Key