C
HAPTER
5
| Interface Configuration
Saving Power
– 156 –
WEB INTERFACE
To display LACP settings and status for the remote side:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Show Information from the Action list.
4. Click Internal.
5. Select a group member from the Port list.
Figure 51: Displaying LACP Port Remote Information
SAVING POWER
Use the Interface > Green Ethernet page to enable power savings mode on
the selected port.
CLI REFERENCES
◆ "power-save" on page 736
◆ "show power-save" on page 737
COMMAND USAGE
◆ IEEE 802.3 defines the Ethernet standard and subsequent power
requirements based on cable connections operating at 100 meters.
Enabling power saving mode can reduce power used for cable lengths
To Next Page
Loading...
