C
HAPTER
31
| Automatic Traffic Control Commands
– 766 –
DEFAULT SETTING
300 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
After the apply timer expires, a control action may be triggered as specified
by the auto-traffic-control action command and a trap message sent as
specified by the snmp-server enable port-traps atc broadcast-control-apply
command or snmp-server enable port-traps atc multicast-control-apply
command.
EXAMPLE
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
auto-traffic-control
release-timer
This command sets the time at which to release the control response after
ingress traffic has fallen beneath the lower threshold. Use the no form to
restore the default setting.
SYNTAX
auto-traffic-control {broadcast | multicast}
release-timer seconds
no auto-traffic-control {broadcast | multicast} release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The time at which to release the control response after
ingress traffic has fallen beneath the lower threshold.
(Range: 1-900 seconds)
DEFAULT SETTING
900 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the delay after which the control response can be
terminated. The auto-traffic-control auto-control-release command must
be used to enable or disable the automatic release.
To Next Page
Loading...
Need help?
General