C
HAPTER
15
| Basic Administration Protocols
Switch Clustering
– 418 –
3. Set the required attributes for a Commander or a managed candidate.
4. Click Apply
Figure 247: Configuring a Switch Cluster
CLUSTER MEMBER
CONFIGURATION
Use the Administration > Cluster (Configure Member - Add) page to add
Candidate switches to the cluster as Members.
CLI REFERENCES
â—† "Switch Clustering" on page 563
PARAMETERS
These parameters are displayed:
◆ Member ID – Specify a Member ID number for the selected Candidate
switch. (Range: 1-36)
◆ MAC Address – Select a discovered switch MAC address from the
Candidate Table, or enter a specific MAC address of a known switch.
WEB INTERFACE
To configure cluster members:
1. Click Administration, Cluster.
2. Select Configure Member from the Step list.
3. Select Add from the Action list.
4. Select one of the cluster candidates discovered by this switch, or enter
the MAC address of a candidate.
5. Click Apply.
To Next Page
Loading...
Need help?
General