C
HAPTER
40
| CFM Commands
– 973 –
COMMAND USAGE
This command can be used to clear AIS defect entries if a MEP does not
exit the AIS state when all errors are resolved.
EXAMPLE
This example clears AIS defect entries on port 1.
Console#clear ethernet cfm ais mpid 1 md voip ma rd
Console(config)#
show ethernet cfm
configuration
This command displays CFM configuration settings, including global
settings, SNMP traps, and interface settings.
SYNTAX
show ethernet cfm configuration {global | traps |
interface interface}
global – Displays global settings including CFM global status, cross-
check start delay, and link trace parameters.
traps – Displays the status of all continuity check and cross-check
traps.
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
This example shows the global settings for CFM.
Console#show ethernet cfm configuration global
CFM Global Status : Enabled
Crosscheck Start Delay : 10 seconds
Linktrace Cache Status : Enabled
Linktrace Cache Hold Time : 100 minutes
Linktrace Cache Size : 100 entries
Console#
To Next Page
Loading...
Need help?
General