C
HAPTER
33
| Spanning Tree Commands
– 794 –
which cover the same general area of your network. However,
remember that you must configure all bridges within the same MSTI
Region (page 794) with the same set of instances, and the same
instance (on each bridge) with the same set of VLANs. Also, note that
RSTP treats each MSTI region as a single node, connecting all regions
to the Common Spanning Tree.
EXAMPLE
Console(config-mstp)#mst 1 vlan 2-5
Console(config-mstp)#
name This command configures the name for the multiple spanning tree region in
which this switch is located. Use the no form to clear the name.
SYNTAX
name name
name - Name of the spanning tree.
DEFAULT SETTING
Switch’s MAC address
COMMAND MODE
MST Configuration
COMMAND USAGE
The MST region name and revision number (page 794) are used to
designate a unique MST region. A bridge (i.e., spanning-tree compliant
device such as this switch) can only belong to one MST region. And all
bridges in the same region must be configured with the same MST
instances.
EXAMPLE
Console(config-mstp)#name R&D
Console(config-mstp)#
RELATED COMMANDS
revision (794)
revision This command configures the revision number for this multiple spanning
tree configuration of this switch. Use the no form to restore the default.
SYNTAX
revision number
number - Revision number of the spanning tree. (Range: 0-65535)
To Next Page
Loading...
Need help?
General