C
HAPTER
14
| Security Measures
Network Access (MAC Address Authentication)
– 290 –
This parameter applies to authenticated MAC addresses configured by
the MAC Address Authentication process described in this section, as
well as to any secure MAC addresses authenticated by 802.1X,
regardless of the 802.1X Operation Mode (Single-Host, Multi-Host, or
MAC-Based authentication as described on page 341).
Authenticated MAC addresses are stored as dynamic entries in the
switch’s secure MAC address table and are removed when the aging
time expires.
The maximum number of secure MAC addresses supported for the
switch system is 1024.
◆ Reauthentication Time – Sets the time period after which a
connected host must be reauthenticated. When the reauthentication
time expires for a secure MAC address, it is reauthenticated with the
RADIUS server. During the reauthentication process traffic through the
port remains unaffected. (Range: 120-1000000 seconds;
Default: 1800 seconds)
WEB INTERFACE
To configure aging status and reauthentication time for MAC address
authentication:
1. Click Security, Network Access.
2. Select Configure Global from the Step list.
3. Enable or disable aging for secure addresses, and modify the
reauthentication time as required.
4. Click Apply.
Figure 156: Configuring Global Settings for Network Access
CONFIGURING
NETWORK ACCESS
FOR
PORTS
Use the Security > Network Access (Configure Interface - General) page to
configure MAC authentication on switch ports, including enabling address
authentication, setting the maximum MAC count, and enabling dynamic
VLAN or dynamic QoS assignments.
CLI REFERENCES
â—† "Network Access (MAC Address Authentication)" on page 654
To Next Page
Loading...
Need help?
General