C
HAPTER
27
| Interface Commands
– 737 –
analyzes cable length to determine whether or not it can reduce the
signal amplitude used on a particular link.
N
OTE
:
Power-savings mode on a active link only works when the
connection speed is 100 Mbps or higher at linkup, and line length is less
than 60 meters.
N
OTE
:
Power savings can only be implemented on Gigabit Ethernet ports
using twisted-pair cabling. Power-savings mode on a active link only works
when connection speed is 1 Gbps, and line length is less than 60 meters.
EXAMPLE
Console(config)#interface ethernet 1/10
Console(config-if)#power-save
Console(config-if)#
show power-save This command shows the configuration settings for power savings.
SYNTAX
show power-save [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show power-save interface ethernet 1/10
Power Saving Status : Enabled
Console#
To Next Page
Loading...
Need help?
General