C
HAPTER
18
| Multicast Filtering
Layer 2 IGMP (Snooping and Query)
– 460 –
SPECIFYING STATIC
INTERFACES FOR A
MULTICAST ROUTER
Use the Multicast > IGMP Snooping > Multicast Router (Add) page to
statically attach an interface to a multicast router/switch.
Depending on network connections, IGMP snooping may not always be able
to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, the interface (and a specified VLAN) can be manually
configured to join all the current multicast groups supported by the
attached router. This can ensure that multicast traffic is passed to all the
appropriate interfaces within the switch.
CLI REFERENCES
â—† "Static Multicast Routing" on page 914
PARAMETERS
These parameters are displayed:
◆ VLAN – Selects the VLAN which is to propagate all multicast traffic
coming from the attached multicast router. (Range: 1-4093)
◆ Interface – Activates the Port or Trunk scroll down list.
◆ Port or Trunk – Specifies the interface attached to a multicast router.
WEB INTERFACE
To specify a static interface attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Add Static Multicast Router from the Action list.
3. Select the VLAN which will forward all the corresponding multicast
traffic, and select the port or trunk attached to the multicast router.
4. Click Apply.
Figure 278: Configuring a Static Interface for a Multicast Router
To show the static interfaces attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Show Static Multicast Router from the Action list.
To Next Page
Loading...
Need help?
General