C
HAPTER
7
| Address Table Settings
Changing the Aging Time
– 197 –
Figure 84: Displaying Static MAC Addresses
CHANGING THE AGING TIME
Use the MAC Address > Dynamic (Configure Aging) page to set the aging
time for entries in the dynamic address table. The aging time is used to
age out dynamically learned forwarding information.
CLI REFERENCES
â—† "mac-address-table aging-time" on page 777
PARAMETERS
These parameters are displayed:
◆ Aging Status – Enables/disables the function.
◆ Aging Time – The time after which a learned entry is discarded.
(Range: 10-844 seconds; Default: 300 seconds)
WEB INTERFACE
To set the aging time for entries in the dynamic address table:
1. Click MAC Address, Dynamic.
2. Select Configure Aging from the Action list.
3. Modify the aging status if required.
4. Specify a new aging time.
5. Click Apply.
To Next Page
Loading...
Need help?
General