C
HAPTER
31
| Automatic Traffic Control Commands
– 775 –
snmp-server enable
port-traps atc
multicast-control-
apply
This command sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc multicast-control-apply
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-apply
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (770)
auto-traffic-control apply-timer (765)
snmp-server enable
port-traps atc
multicast-control-
release
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc
multicast-control-release
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-
release
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-clear-threshold (769)
auto-traffic-control action (768)
auto-traffic-control release-timer (766)
To Next Page
Loading...
Need help?
General