C
HAPTER
24
| Authentication Commands
TACACS+ Client
– 607 –
port-number - TACACS+ server TCP port used for authentication
messages. (Range: 1-65535)
retransmit - Number of times the switch will try to authenticate
logon access via the TACACS+ server. (Range: 1-30)
timeout - Number of seconds the switch waits for a reply before
resending a request. (Range: 1-540)
DEFAULT SETTING
authentication port - 49
timeout - 5 seconds
retransmit - 2
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#tacacs-server host 192.168.1.25
Console(config)#
tacacs-server key This command sets the TACACS+ encryption key. Use the no form to
restore the default.
SYNTAX
tacacs-server key key-string
no tacacs-server key
key-string - Encryption key used to authenticate logon access for
the client. Do not use blank spaces in the string.
(Maximum length: 48 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#tacacs-server key green
Console(config)#
tacacs-server port This command specifies the TACACS+ server network port. Use the no
form to restore the default.
SYNTAX
tacacs-server port port-number
To Next Page
Loading...
Need help?
General