C
HAPTER
27
| Interface Commands
– 733 –
show interfaces
transceiver
This command displays identifying information for the specified transceiver,
as well as the temperature, voltage, bias current, transmit power, and
receive power.
SYNTAX
show interfaces transceiver [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: SFP ports 9-10)
DEFAULT SETTING
Shows all SFP interfaces.
COMMAND MODE
Privileged Exec
Unknown-unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if
enabled it also shows the threshold level (page 727).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 742).
Ingress/Egress
Rate Limit
Shows if rate limiting is enabled, and the current rate limit (page 761).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 836).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 835).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 834).
Native VLAN Indicates the default Port VLAN ID (page 837).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 866).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled
(page 828).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates
untagged and “(t)” indicates tagged (page 834).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
(page 828).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface (page 841).
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Uplink (page 842).
802.1Q-tunnel
TPID
Shows the Tag Protocol Identifier used for learning and switching packets
(page 844).
Table 91: show interfaces switchport - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General