C
HAPTER
38
| Multicast Filtering Commands
Multicast VLAN Registration
– 925 –
mvr upstream-
source-ip
This command configures the source IP address assigned to all MVR control
packets sent upstream on the specified domain. Use the no form to restore
the default setting.
SYNTAX
mvr upstream-source-ip source-ip-address
no mvr upstream-source-ip
source-ip-address – The source IPv4 address assigned to all MVR
control packets sent upstream.
DEFAULT SETTING
All MVR reports sent upstream use a null source IP address
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#mvr upstream-source-ip 192.168.0.3
Console(config)#
mvr vlan This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
SYNTAX
mvr vlan vlan-id
no mvr vlan
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4093)
DEFAULT SETTING
VLAN 1
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† This command specifies the VLAN through which MVR multicast data is
received. This is the VLAN to which all source ports must be assigned.
â—† The VLAN specified by this command must be an existing VLAN
configured with the vlan command.
â—† MVR source ports can be configured as members of the MVR VLAN
using the switchport allowed vlan command and switchport native vlan
To Next Page
Loading...
Need help?
General