C
HAPTER
31
| Automatic Traffic Control Commands
– 771 –
auto-traffic-control
auto-control-release
This command automatically releases a control response after the time
specified in the auto-traffic-control release-timer command has expired.
SYNTAX
auto-traffic-control {broadcast | multicast}
auto-control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
This command can be used to automatically stop a control response after
the specified action has been triggered and the release timer has expired.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
auto-traffic-control
control-release
This command manually releases a control response.
SYNTAX
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
This command can be used to manually stop a control response any time
after the specified action has been triggered.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release interface
ethernet 1/1
Console#(config-if)
To Next Page
Loading...
Need help?
General