C
HAPTER
17
| IP Services
Configuring Static DNS Host to Address Entries
– 449 –
To show the list name servers:
1. Click IP Service, DNS.
2. Select Show Name Servers from the Action list.
Figure 272: Showing the List of Name Servers for DNS
CONFIGURING STATIC DNS HOST TO ADDRESS ENTRIES
Use the IP Service > DNS - Static Host Table (Add) page to manually
configure static entries in the DNS table that are used to map domain
names to IP addresses.
CLI REFERENCES
â—† "ip host" on page 1014
â—† "show hosts" on page 1018
COMMAND USAGE
â—† Static entries may be used for local devices connected directly to the
attached network, or for commonly used resources located elsewhere
on the network.
PARAMETERS
These parameters are displayed:
◆ Host Name – Name of a host device that is mapped to one or more IP
addresses. (Range: 1-127 characters)
◆ IP Address – Internet address(es) associated with a host name.
To Next Page
Loading...
Need help?
General