C
HAPTER
35
| VLAN Commands
Configuring VLAN Interfaces
– 837 –
EXAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
RELATED COMMANDS
switchport acceptable-frame-types (834)
switchport native
vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use
the no form to restore the default.
SYNTAX
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093, no leading
zeroes)
DEFAULT SETTING
VLAN 1
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
â—† When using Access mode, and an interface is assigned to a new VLAN,
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
â—† If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
EXAMPLE
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
To Next Page
Loading...
Need help?
General