C
HAPTER
21
| System Management Commands
Event Logging
– 549 –
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear log
Console#
RELATED COMMANDS
show log (549)
show log This command displays the log messages stored in local memory.
SYNTAX
show log {flash | ram}
flash - Event history stored in flash memory (i.e., permanent
memory).
ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
â—† All log messages are retained in RAM and Flash after a warm restart
(i.e., power is reset through the command interface).
â—† All log messages are retained in Flash and purged from RAM after a
cold restart (i.e., power is turned off and then on through the power
source).
EXAMPLE
The following example shows the event message stored in RAM.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
To Next Page
Loading...
Need help?
General