C
HAPTER
38
| Multicast Filtering Commands
Multicast VLAN Registration
– 922 –
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
Using this command without specifying an interface displays all interfaces.
EXAMPLE
Console#show ip igmp throttle interface ethernet 1/1
Eth 1/1 Information
Status : TRUE
Action : Deny
Max Multicast Groups : 32
Current Multicast Groups : 0
Console#
MULTICAST VLAN REGISTRATION
This section describes commands used to configure Multicast VLAN
Registration (MVR). A single network-wide VLAN can be used to transmit
multicast traffic (such as television channels) across a service provider’s
network. Any multicast traffic entering an MVR VLAN is sent to all
subscribers. This can significantly reduce to processing overhead required
to dynamically monitor and establish the distribution tree for a normal
multicast VLAN. Also note that MVR maintains the user isolation and data
security provided by VLAN segregation by passing only multicast traffic into
other VLANs to which the subscribers belong.
Table 131: Multicast VLAN Registration Commands
Command Function Mode
mvr Globally enables MVR GC
mvr group Statically configures MVR group address(es) GC
mvr priority Assigns a priority to all multicast traffic in the MVR
VLAN
GC
mvr upstream-source-ip Configures the source IP address assigned to all
control packets sent upstream
GC
mvr vlan Specifies the VLAN through which MVR multicast data
is received
GC
mvr immediate-leave Enables immediate leave capability IC
mvr type Configures an interface as an MVR receiver or source
port
IC
mvr vlan group Statically binds a multicast group to a port IC
show mvr Shows information about the global MVR configuration
settings, interfaces attached to the MVR VLAN, or the
multicast groups assigned to the MVR VLAN
PE
To Next Page
Loading...
Need help?
General