Edge-Core ES3510MA-DC - Showing the MTU for Responding Destinations; Table 34: Show MTU - Display Description; Figure 266: Showing Ipv6 Statistics (UDP)

C HAPTER 16 | IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 444 –
Figure 266: Showing IPv6 Statistics (UDP)
SHOWING THE MTU
FOR RESPONDING
DESTINATIONS
Use the IP > IPv6 Configuration (Show MTU) page to display the maximum
transmission unit (MTU) cache for destinations that have returned an ICMP
packet-too-big message along with an acceptable MTU to this switch.
CLI REFERENCES
◆ "show ipv6 mtu" on page 1046
PARAMETERS
These parameters are displayed:
WEB INTERFACE
To show the MTU reported from other devices:
1. Click IP, IPv6 Configuration.
2. Select Show MTU from the Action list.
Figure 267: Showing Reported MTU Values
Table 34: Show MTU - display description
Field Description
MTU Adjusted MTU contained in the ICMP packet-too-big message returned from
this destination, and now used for all traffic sent along this path.
Since Time since an ICMP packet-too-big message was received from this
destination.
Destination
Address
Address which sent an ICMP packet-too-big message.