Edge-Core ES3510MA-DC - Figure 45: Configuring LACP Parameters on a Port

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 151 –
Figure 45: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Show Member from the Action List.
4. Select a Trunk.
Figure 46: Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Configure from the Action List.
4. Modify the required interface settings. (See "Configuring by Port List"
on page 127 for a description of the interface settings.)
5. Click Apply.