Edge-Core ES3510MA-DC - Figure 213: Displaying Remote Device Information for LLDP (Port)

C HAPTER 15 | Basic Administration Protocols
Link Layer Discovery Protocol
– 379 –
◆ Remote Power Classification – This classification is used to tag
different terminals on the Power over LAN network according to their
power consumption. Devices such as IP telephones, WLAN access
points and others, will be classified according to their power
requirements.
Port Details – 802.3 Extension Trunk Information
◆ Remote Link Aggregation Capable – Shows if the remote port is not
in link aggregation state and/or it does not support link aggregation.
◆ Remote Link Aggregation Status – The current aggregation status
of the link.
◆ Remote Link Aggregation Port ID – This object contains the IEEE
802.3 aggregated port identifier, aAggPortID (IEEE 802.3-2002,
30.7.2.1.1), derived from the ifNumber of the ifIndex for the port
component associated with the remote system. If the remote port is
not in link aggregation state and/or it does not support link
aggregation, this value should be zero.
Port Details – 802.3 Extension Frame Information
◆ Remote Max Frame Size – An integer value indicating the maximum
supported frame size in octets on the port component associated with
the remote system.
WEB INTERFACE
To display LLDP information for a remote port:
1. Click Administration, LLDP.
2. Select Show Remote Device Information from the Step list.
3. Select Port, Port Details, Trunk, or Trunk Details.
Figure 213: Displaying Remote Device Information for LLDP (Port)