C
HAPTER
32
| Address Table Commands
– 780 –
■
Learn - Dynamic address entries
■
Config - Static entry
◆ The mask should be hexadecimal numbers (representing an equivalent
bit mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified
MAC address. Enter hexadecimal numbers, where an equivalent binary
bit “0” means to match a bit and “1” means to ignore a bit. For
example, a mask of 00-00-00-00-00-00 means an exact match, and a
mask of FF-FF-FF-FF-FF-FF means “any.”
◆ The maximum number of address entries is 16K.
EXAMPLE
Console#show mac-address-table
Interface MAC Address VLAN Type Life Time
--------- ----------------- ---- -------- -----------------
Eth 1/ 1 00-E0-29-94-34-DE 1 Config Delete on Reset
Eth 1/21 00-01-EC-F8-D8-D9 1 Learn Delete on Timeout
Console#
show mac-address-
table aging-time
This command shows the aging time for entries in the address table.
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show mac-address-table aging-time
Aging Status : Enabled
Aging Time: 300 sec.
Console#
To Next Page
Loading...
Need help?
General