C
HAPTER
14
| Security Measures
Access Control Lists
– 325 –
Figure 181: Configuring a ARP ACL
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI REFERENCES
â—† "ip access-group" on page 702
â—† "show ip access-group" on page 703
â—† "mac access-group" on page 713
â—† "show mac access-group" on page 714
â—† "Time Range" on page 560
COMMAND USAGE
â—† This switch supports ACLs for ingress filtering only.
â—† You only bind one ACL to any port for ingress filtering.
PARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier.
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.
To Next Page
Loading...
Need help?
General