C
HAPTER
4
| Basic Management Tasks
Managing System Files
– 105 –
PARAMETERS
The following parameters are displayed:
◆ Copy Type – The firmware copy operation includes these options:
■
TFTP Upgrade – Copies a file from a TFTP server to the switch.
■
TFTP Download – Copies a file from the switch to a TFTP server.
■
HTTP Upgrade – Copies a file from a management station to the
switch.
■
HTTP Download – Copies a file from the switch to a management
station
◆ TFTP Server IP Address – The IP address of a TFTP server.
◆ File Type – Specify Operation Code to copy firmware.
◆ File Name –
The file name should not contain slashes (\ or /),
the
leading letter of the file name should not be a period (.), and the
maximum length for file names is 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
N
OTE
:
Up to two copies of the system software (i.e., the runtime firmware)
can be stored in the file directory on the switch.
N
OTE
:
The maximum number of user-defined configuration files is limited
only by available flash memory space.
N
OTE
:
The file
“
Factory_Default_Config.cfg
”
can be copied to a TFTP server
or management station, but cannot be used as the destination file name on
the switch.
WEB INTERFACE
To copy firmware files:
1. Click System, then File.
2. Select Copy from the Action list.
3. Select HTTP Upgrade or TFTP Upgrade as the file transfer method.
4. If TFTP Upgrade is used, enter the IP address of the file server.
5. Set the file type to Operation Code.
6. Enter the name of the file to download.
7. Select a file on the switch to overwrite or specify a new file name.
8. Then click Apply.
To Next Page
Loading...
