C
HAPTER
19
| Using the Command Line Interface
CLI Command Groups
– 497 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for DSCP
863
Quality of Service Configures Differentiated Services 877
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a
multicast router; also configures multicast VLAN
registration
895
Link Layer Discovery
Protocol
Configures LLDP settings to enable information
discovery about neighbor devices
933
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
957
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and
maintain the links to subscriber CPEs
1001
Domain Name Service Configures DNS services. 1011
Dynamic Host
Configuration Protocol
Configures DHCP client functions 1021
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
1027
Table 38: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
