C
ONTENTS
– 9 –
Trunk Configuration 144
Configuring a Static Trunk 145
Configuring a Dynamic Trunk 147
Displaying LACP Port Counters 152
Displaying LACP Settings and Status for the Local Side 154
Displaying LACP Settings and Status for the Remote Side 155
Saving Power 156
Traffic Segmentation 158
Enabling Traffic Segmentation 158
Configuring Uplink and Downlink Ports 159
VLAN Trunking 161
6 VLAN CONFIGURATION 165
IEEE 802.1Q VLANs 165
Configuring VLAN Groups 168
Adding Static Members to VLANs 170
Configuring Dynamic VLAN Registration 175
IEEE 802.1Q Tunneling 178
Enabling QinQ Tunneling on the Switch 182
Adding an Interface to a QinQ Tunnel 183
Protocol VLANs 184
Configuring Protocol VLAN Groups 185
Mapping Protocol Groups to Interfaces 187
Configuring IP Subnet VLANs 189
Configuring MAC-based VLANs 191
Configuring VLAN Mirroring 193
7ADDRESS TABLE SETTINGS 195
Setting Static Addresses 195
Changing the Aging Time 197
Displaying the Dynamic Address Table 198
Clearing the Dynamic Address Table 199
Configuring MAC Address Mirroring 200
8SPANNING TREE ALGORITHM 203
Overview 203
Configuring Loopback Detection 206
Configuring Global Settings for STA 207
Displaying Global Settings for STA 212
To Next Page
Loading...
Need help?
General