C
HAPTER
3
| Using the Web Interface
Navigating the Web Browser Interface
– 93 –
Add Adds an ACL based on IP or MAC address filtering 312
Show Shows the name and type of configured ACLs 312
Add Rule Configures packet filtering based on IP or MAC addresses and other
packet attributes
312
Show Rule Shows the rules specified for an ACL 312
Configure Interface Binds a port to the specified ACL and time range 325
ARP Inspection 326
Configure General Enables inspection globally, configures validation of additional
address components, and sets the log rate for packet inspection
327
Configure VLAN Enables ARP inspection on specified VLANs 329
Configure Interface Sets the trust mode for ports, and sets the rate
limit for packet inspection
331
Show Information
Show Statistics Displays statistics on the inspection process 332
Show Log Shows the inspection log list 333
IP Filter 334
Add Sets IP addresses of clients allowed management access via the
web, SNMP, and Telnet
334
Show Shows the addresses to be allowed management access 334
Port Security Configures per port security, including status, response for security
breach, and maximum allowed MAC addresses
336
Port Authentication IEEE 802.1X 338
Configure Global Enables authentication and EAPOL pass-through 339
Configure Interface Sets authentication parameters for individual ports 341
Show Statistics Displays protocol statistics for the selected port 347
IP Source Guard Filters IP traffic based on static entries in the IP Source Guard table,
or dynamic entries in the DHCP Snooping table
350
Port Configuration Enables IP source guard and selects filter type per port 350
Static Binding 352
Add Adds a static addresses to the source-guard binding table 352
Show Shows static addresses in the source-guard binding table 352
Dynamic Binding Displays the source-guard binding table for a selected interface 354
Administration 363
Log 363
System 363
Configure Global Stores error messages in local memory 363
Show System Logs Shows logged error messages 363
Remote Configures the logging of messages to a remote logging process 366
SMTP Sends an SMTP client message to a participating server 367
Table 6: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
