4.7 Configuring the Network Settings
108
4.7.7 Configuring Network Advanced Settings
Set the Link Speed/Duplex Mode and Wake On LAN.
Also set whether or not to use the IPv6 function. For details about the IPv6 function, refer
to "Appendix G IPv6 Settings" (page 456).
1. Select [Network Advanced Settings] under [Network Settings].
The [Network Advanced Settings] window appears.
2. Specify each item.
3. Press the [OK] button.
The information entered is set.
HINT
The connection with the scanner is lost if the IPv6 function is changed via the Admin Tool. To
continue with other settings, close the Admin Tool and then access the scanner via the Admin
Tool again.
To Next Page
Loading...
