4.14 Setting the Network Printers
149
(b-2) Registering a Network Printer and Then Selecting a Driver for the
Network Printer
1. Register a network printer.
When you add a network printer without a print server by using the relevant driver
for the network printer that is registered in [Printer List], you do not need to register
a new network printer. Proceed to the next step.
2. Check the printer name or the IP address for the printer.
For details, refer to "Checking the Printer Name or the IP Address for the Printer (for
Direct Printing)" (page 153).
3. Check the driver name for the printer.
For details, refer to "Checking the Driver Name for the Printer (for Direct Printing)"
(page 153).
4. Register a network printer without a print server.
Directly enter each item of the settings for network printers.
Up to 100 network printers can be registered.
For details, refer to "Registering a Network Printer (Network Path)" (page 156). For
Step 4, refer to (b-2).
HINT
To register a new network printer, refer to "(a) Setting a Network Printer via a Print
Server" (page 147) or "(b-1) Downloading a Driver from a Computer on Which a Network
Printer Is Published and Using the Driver" (page 148).
ATTENTION
Do not delete the network printer settings that were used to set a network printer without
a print server from the computer. If the settings are removed, the corresponding driver is
also removed from the scanner, and it may cause an error in printing.
To Next Page
Loading...
