4.5 Setting the Scan Options
90
4.5.2 Adjusting the Scan Starting Position (Offset/
Magnification)
Usually, it is not necessary to make any setting changes.
Configure the following setting items.
Offset settings
When the scanned output is found to be displaced relative to the actual documents
being scanned, the scan offsets can be adjusted.
Length magnification setting
If the scanned output is found to be vertically distorted (stretched or squashed)
relative to the actual documents being scanned, the length magnification in the
vertical scanning direction can be adjusted.
1. Select [Scanner Adjustment] under [Scanner Settings].
The [Scanner Adjustment] window appears.
2. Specify each item.
3. Press the [OK] button.
The information entered is set.
To Next Page
Loading...
