Fujitsu N7100 User Manual

341
Chapter 6
Scanner Care
This chapter describes how to clean the scanner and replace parts in order to maintain
the scanner in optimum scanning condition.
6.1 Cleaning Supplies and Parts to Clean .............................................................. 342
6.2 Cleaning the Exterior of the Scanner................................................................ 344
6.3 Cleaning Inside the Scanner.............................................................................. 345
6.4 Cleaning a Carrier Sheet .................................................................................... 351
6.5 Replacing Parts................................................................................................... 352
6.6 Performing a Scan Test...................................................................................... 362
6.7 Calibrating the Touch Panel............................................................................... 365
Admin
User
WARNING
Do not use any aerosol sprays or alcohol-based sprays to clean the
scanner. Dust blown up by strong air from the spray may enter the
inside of the scanner. This may cause the scanner to fail or
malfunction.
Sparks, caused by static electricity, generated when blowing off dust
and dirt from the outside of the scanner may cause a fire.
CAUTION
The glass inside the ADF can become hot when the scanner is used.
Before cleaning the inside of the scanner or replacing any parts, turn off
the power, unplug the power cable from the AC outlet, and wait for at
least 15 minutes.
Clean the feed rollers and eject rollers when the power is on.
Before replacing any parts, turn off the power, unplug the power cable
from the AC outlet, and wait for at least 15 minutes.

Fujitsu N7100 Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 3048 mm
Output color depth	24 bit
ADF scan speed (b/w, A4)	25 ppm
Optical scanning resolution	600 x 600 DPI
Duplex ADF scan speed (b/w, A4)	50 ipm
Black/white scanning color modes	Grayscale, Monochrome
Display	LCD
Scanner type	ADF scanner
Product color	Black
Display diagonal	8.4 \
Display resolution	1024 x 768 pixels
Scan to	E-mail, E-mail Server, Fax, File, FTP
Sensor type	CIS
Scan file formats	JPG, PDF, TIFF
Daily duty cycle (max)	400 pages
Supported network protocols	TCP/IP(IPv4 / IPv6), DNS, DHCP, SMTP, SMB, LDAP, NTP, FTP, HTTP, SNMP
Auto document feeder (ADF) input capacity	50 sheets
Maximum scan area (ADF)	216 x 355.6 mm
Minimum scan area (ADF)	50.8 x 50.8 mm
ISO A-series sizes (A0...A9)	A4, A5, A6, A8
ISO B-series sizes (B0...B9)	B5, B6
Scanning media types supported	Business Card, Plain paper, Plastic Card, Post Card(JPN), Thick paper, Thin paper
Maximum ISO A-series paper size	A4
Auto Document Feeder (ADF) media weight	40 - 209 g/m²
USB version	2.0
Standard interfaces	Ethernet, USB 1.1, USB 2.0
Input voltage	100-240 V
Power supply type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	1 W
Power consumption (typical)	38 W
Power consumption (PowerSave)	2 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Sustainability certificates	RoHS, ENERGY STAR
Bundled software	Scanner Central Admin Server
Ethernet LAN data rates	10, 100, 1000 Mbit/s

Weight and Dimensions

Depth	232 mm
Width	300 mm
Height	172 mm
Weight	6000 g