Fujitsu PRIMERGY RX900 S2 - Page 367

RX900 S2 Upgrade and Maintenance Manual 367
Appendix
*1) The SAS RAID controller shall not be installed in PCIe slot #1 to #7 on the
PCI Riser when a BBU is connected because of limited length of the BBU cable.
*2) No mix with FC controller possible.
*3) Capacity: 160 GB, 320 GB, 640 GB
*4) Capacity: 320 GB, 640 GB, 1280 GB
FTS GbEx2
(D2735)
Gen1 x4 8 x x x x x x x
GbEx4
(D2745)
Gen2 x4 8 x x x x x x
10GbEx2
(D2755)
Gen2 x8 8 x x x x x x
Mellanox IB-QDRx1 Gen2 x8 2 x x x x x x
IB-QDRx2 Gen2 x8 2 x x x x x x
Fusion-
IO
ioDRIVE
(*3)
Gen1 x4 4 x x x x x x x
ioDRIVE
(*4)
Gen1 x4 4 x x x x x x x
Chipset IOH#1 IOH#2
Bus scan order 3 2 1 5 6 4 7 8
I/O space assignment order within the
I/O Hub (IOH)
12343 21
Hot-plug nnnnnnnn
Gen2 width x8x8x8x8x8x4x8x8
Slot # 12834567
Vendor Type PCIe Max #
Table 11: Expansion card installation recommendation I/O Hubs IOH#1 and IOH#2