GE LOGIQ P9

GEDRAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-57
3-12-2 Wired Ethernet from LOGIQ P9/P7 to a Workstation
3-12-2-1 Direct Cable Connection from the LOGIQ P9/P7 to a Workstation via a Crossover Cable.
You will only need a Crossover Cable for network use to connect the two units this way.
1) Connect one end of the crossed network cable to the network connector on the LOGIQ P9/P7.
2) Connect the other end to the network connector to the Workstation, see the Workstation Service
Manual.
3-12-2-2 Connection via a Peer-to-Peer Network
You will need a network switch and one network cable for each unit connected to the switch.
3-12-2-3 Connection via Hospital Network
3-12-2-4 You will need one network cable to connect the LOGIQ P9/P7 to a wall outlet on the hospital’s network.
3-12-3 Connection using Wireless Option
Refer to:
- Chapter 5 for theory.
- LOGIQ P9/P7 Basic User Manual: Chapter 16 Configuring Connectivity.