GEDRAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-19
3-6-7 General Remarks and Hints when using external USB-Devices
3-6-7-1 External USB-Devices - Connection
When an external USB-storage device (such as a USB-memory stick or an external hard disk) is
connected to the LOGIQ P9/P7, Windows detects the device and automatically installs a driver. During
this process, several dialogs may pop up, starting with the “Found New Hardware“ dialog.
The device is then accessible using the drive letter the system assigned to it.
3-6-7-2 External USB-Devices - Disconnection
To stop the external device, press F3 EJECT
button.
!! WARNING:
Do not connect or disconnect any external USB-devices to or from the system while
scanning a patient! The appearing dialogs could distract you from the scan!
!! NOTICE:
When connecting external USB devices, be sure to execute Safety Directions found in the
LOGIQ P9/P7 Basic User Manual.
!! CAUTION:
Unplugging or ejecting USB devices without first stopping them can often cause the system to
crash and possibly result in loss of valuable data.
To Next Page
Loading...
