GERAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
3-26 Section 3-7 - Completing the Set Up
• Logoff
Use this button to log off the current user. The system remains ON and ready for a new user to log
on. If the Logoff button is dimmed, it indicates that no user is logged on to the unit at the moment.
• Shutdown
Use this button to shut down the system. The entire system will shut down. It is recommended to
perform a full shutdown at least once a week.
If the Shutdown button is dimmed, press the power button or Alt F10 to shut down the unit.
•Cancel
Use this button to exit from the System-Exit menu and return to the previous operation.
• Exit (Only available when logged in as GE Service with Service Dongle)
Select this button when you want to exit to the Windows Desktop.
• Sleep (R2 and R2.5 Only)
Use Sleep Mode when you do a portable exam in order to reduce the time to start up the system.
When you use Sleep Mode, it takes ~90 seconds to start up the system versus 2-3 minutes.
•Change Password
Use this button to change User Password.
Refer to Section 4-2-5-4 "Sleep Mode Check" on page 4-14.
!! NOTICE:
After turning off a system, wait at least 10 seconds before turning it on again.
The system may not be able to boot if power is recycled too quickly.
To Next Page
Loading...
Need help?
General
