GRAPHTEC CE8000 Series - Page 232

15-12
Error
Displayed
LCD Display Cause Solution
E01019 Load on the motor was too large. Move the object disturbing the operation, and
turn on the plotter after turning it off once.
Do not use heavy media.
Contact your sales representative or the
Graphtec call center if the error still appears.
E01021 Load on the motor was too large. Move the object disturbing the operation, and
turn on the plotter after turning it off once.
Do not use heavy media.
Contact your sales representative or the
Graphtec call center if the error still appears.
E01022 There was a heavy load on the up and down
function of the tool carriage.
Please clear any obstruction in the up and
down function of the tool carriage and turn
the power back on.
Contact your sales representative or the
Graphtec call center if the error still appears.
E01029 An error has occurred in the wireless LAN
module.
Turn the power off and then on again.
Contact your sales representative or the
Graphtec call center if the error still appears.
E05001 Data larger than the buffer size cannot be
copied.
Perform normal cutting not using the copy
mode.
E05002 There is no data to copy. Perform normal cutting by sending the data,
then use the copy mode.
E05003 Media valid area to copy is too small. Use larger media. Confirm the copy start
position.
E05004 The push roller is not on the grit roller. Set the push roller on the grit roller.
E05006 Distance between the bottom left and top
right of the AREA setting is less than 10 mm.
Perform the AREA setting again.
E05007 Test pattern for the TOOL OFFSET ADJ.
cannot start plotting because the start
position is at the edge of the media.
Set the start position inside the media.
E05008 External memory (USB memory) cannot be
recognized.
Insert external memory (USB memory).
E05009 Bar Code cannot be scanned. Check the print result of Bar Code.