15-13
Error
Displayed
LCD Display Cause Solution
E05010 Bar Code cutting is not available when
Rotation is set to ON.
Set Rotation is set to OFF to use Bar Code
cutting.
E05011 Bar Code cutting is not available when
Mirror is set to ON.
Set Mirror is set to OFF to use Bar Code
cutting.
E05012 The desired file cannot be found in external
memory (USB memory).
Save the desired file in external memory (USB
memory).
E05013 Start mark cannot be scanned. Check the print result of start mark.
Move the tool carriage above the start mark.
E05014 The selected connection destination cannot
be found.
Connect to the selected connection
destination using USB or LAN cable.
E05015 There is no appropriate cutting data for the
data link server.
Check the data link server.
E05016 The communication to the data link server is
not established.
Check the data link server.
Increase the time until the timeout.
E05017 Media set lever is lowered. Set the media again.
E05018 A trouble occurs in the data link server. Restart the data link server.
E05019 A trouble occurs in communication to the
data link server.
Set the media again.
Turn the power off and then on again.
E05020 The connection destination is not USB
memory.
Set connection destination to USB memory.
E05021 The type of bar code is different. Apply the appropriate bar code.
To Next Page
Loading...
