Honda InterceptorVF700F - VFR7500021.PDF

IIONITDA
V45
INTER,CEPTOR
LUBRICATION
ENOIIIT
OIt
LEIJEL
Put
the motorcycle on
its
center stand on level
ground.
Start
the engine and let it idle for
2-3
minutes. Turn off the engine. Remove the filler
cap/dipstick,
wipe
it clean and insert
it without
screwing
it in. Remove
the filler
cap/dipstick and
check the
oil
level.
lf
the
level
is below the lower level mark on the
dipstick, fill
to the upper
level
mark with recom-
mended oil.
Check the oil
pressure
with the oil
pressure
warn-
ing light after the engine starts. The light
should
go
off
after one
or
two seconds.
lf it
does
not,
stop
the engine and
check the
oil
pump
output and/or
oil
circuit.
ENOINE
OIt
&
FIITTR
C|IAI{GE
NOTE
Change
engine
oil with the engine
warm
and
the
motorcycle on its center
stand to assure
complete and rapid
draining.
Stop
the engine.
Remove
the
oil
filler
cap/dipstick,
oil
drain
plug
and
drain
the
oil.
Remove
the lower
radiator
cowl,
lower radiator
mounting
bolts
and brakcet.
Swing the
radiator
away from
the engine,
but
don't disconnect
its
hoses.
Remove
the oil f
ilter
with a filter
wrench
and
let
the remaining
oil
drain out.
Discard
the oil
f ilter.
Check that
the sealing
washer
on the drain
plug
is
in
good
condition
and install
the
plug.
Replace
the
oil
filter
with a new
one.
Check that
the oil filter
O-ring is in
good
condition,
and
coat it
with oil
before installing
it. lnstall
the lower
radiator
mount
bracket,
lower
radiator
mount
bolts
and
lower
radiator
cowl.
Fill
the
crankcase
with
2.9
liters
(3.1
US
qt,
2.b
lmp
qt)
of the
recommended
oil
(page
2-1).
Rein-
stall the
oil
filler
cap/dipstick.
Start
the
engine
and let it
idle for
2-3 minutes.
then
stop the
engine.
Make
sure that
the oil level
is at the
upper
level
mark
on the dipstick.
Make
sure that
there
are
no
oil leaks.
LOWER
R-ADIATOR
OIL
FILLER
/DIPSTICK
OIL
DRAIN PLUG
OIL
FILTER
MOUNT
BOLT
MOUNT
BRACKET
2-3
Date
of lssue:
January, 1983
O
HONDA MOTOR
CO..
LTD.