12. Attach the power cord retainer to the PDM to ensure that the AC power cords do not touch or block
access to router components, and that they do not drape where people could trip on them.
Figure 184 on page 388 shows the seven-feed and nine-feed power cord retainer.
Figure 184: MX2000 Single-Phase AC Power Cord Retainer
•
Loosen the two screws at each end of the power cord retainer.
•
Position the power cord retainer over the PDM power cords with the power cord retainer prongs
facing downward. Refer to Figure 185 on page 389.
388
To Next Page
Loading...
