KAESER SIGMA CONTROL 2 User Manual

6. Press the «Enter» key.
The setting is applied accordingly.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.2.3 Load control
Menu
▶1 pA/pB Clock
·········
pA/pB Cycle
pA : 10h – 10h pB : 18 h – 18h
Active line, manually set setpoint value – automati‐
cally elapsing value (example)
1.Start pA ¦ 00:00
·········
7. Press the «Right» key.
8. Set the cycle duration for pB in the same way.
9. Press «Enter».
The cycle duration for the nominal pressure pA and pB is set.
8.9.3.2 Set starting time for pA or pB
1. Use the «Up» or «Down» keys to select the 1.Start pA line.
2. Press the «Right» key.
3. Press the «Enter» key.
The display for hours, 00: 00 flashes.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.2.3 Load control
Menu
▶1 pA/pB Clock
·········
pA/pB Cycle
pA : 10h – 10h pB : 18 h – 18h
1.Start pA ¦ 06:30AM
Active line, starting time
·········
4. Use «Up» or «Down» to set the hours.
5. Press the «Right» key.
The minutes display, 00 : flashes.
6. Use «Up» or «Down» keys to set the minutes.
7. Press the «Enter» key.
Result The starting time for pA is set.
The cycle is set to start with pB .
➤ Press the «Enter» key and adjust with «Up» 1.Start pB key.
8.9.3.3 Setting local mode
Precondition Password access level 2 is activated.
The timing program or timer is set up.
8 Initial Start-up
8.9 Setting the machine for local mode
118
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet