KAESER SIGMA CONTROL 2 - Setting the maintenance interval; Performing the test; Correct conclusion of the test

9.8 Displaying operating data
The following information can be called up in the Operating data menu:
■ Operating hours
─ Compressor: Total machine running time
─ On load: Machine running time in LOAD mode
─ Motor: Running time of compressor motor (adjustable)
─ Compressor block: Running time of airend (adjustable)
─ SIGMA CONTROL 2: Controller running time
■ Switching cycles
─ Load valve on
─ Mains contactor on (adjustable)
■ kWh counter
➤ Reset the run times after replacing the compressor block or the compressor motor.
➤ Reset the main contactor switching cycle counter after replacing the main contactor.
9.8.1 Checking the operating hours
Display the operating hours
Precondition Password access level 2 is activated.
1. Open the 3 Operating data menu.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
3 Operating data
Menu
▶1 Operating hours
Active line
▶2 Switching cycles
▶3 kWh counter
Changing the operating hours
The running times of the compressor motor and airend components can be adjusted. This may be
required after replacing a component, for example.
Precondition Password access level 2 is activated.
9 Operation
9.8 Displaying operating data
182
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE