KAESER SIGMA CONTROL 2 User Manual

2. Open the 8.1.2.1 <Communication – Ethernet/SIGMA NETWORK – Connections – SIGMA
CONTROL 2> menu.
3. Use «Up» or «Down» to select the Mode line.
4. Press the «Enter» key.
Setting mode is active.
5. Use the «Up» or «Down» key to set machine 2 to Slave .
6. Press the «Enter» key.
The setting is applied.
7. Use «Up» or «Down» to select the IP address line.
8. Press the «Enter» key.
The setting mode is active.
9. Set the IP address of the communication partner (master, see above example).
10. Press «Enter».
The setting is applied.
Result The controller of machine 2 is set as slave.
8.10.5 Configuring master control using the LOAD remote contact (e.g.
SIGMA AIR MANAGER BASIC)
3)
Overview
■ Establish the electrical connection for LOAD remote contact
■ Set the LOAD remote contact operating mode and assign the input
■ If required, set temporary pressure increase pE .
■ Activating the «remote control» key
3)
PISTON: Applies only to Airbox
➤ Set master control as described below:
8 Initial Start-up
8.10 Configuring the machine for master control
138
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet