KAESER SIGMA CONTROL 2 User Manual

8 Initial Start-up
8.1 Outline
SIGMA CONTROL 2 was designed and developed for a number of applications. Potential settings
are correspondingly varied.
It is possible that only a few of these settings are needed for the initial start-up. This depends on
the application .
The following sections explain the large number of practical applications, but only one configuration
is relevant for a specific use.
8.2: Configuring the controller (display format, units, languages, etc.)
8.3: Using KAESER CONNECT
8.4: Pressure parameters of the machine
8.5: Machine start and stop
8.6: Control modes
8.7: Electronic Thermal Management
8.8: Refrigerated dryer
8.9: Configuring the machine for local mode
8.10: Configuring the machine for master control operation
8.11: Configuring input and output signals
8.13: Activating remote acknowledgement
8.14: Linking to an external pressure transducer
8.15: Commissioning the machine
8.2 Setting the controller
The following chapters describe in detail the basic settings for the SIGMA CONTROL 2. The
quick installation guide at the beginning of this operating manual provides an overview of the
essential displays and operating elements, the main menu and important functions.
8 Initial Start-up
8.1 Outline
No.: 9_9450 13 USE
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2
53

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet