KAESER SIGMA CONTROL 2 - Graphs menu

Set the temperature display units
Set the temperature unit for display:
Format Example
°C 46°C
K 319K
°F 114°F
Tab. 48 Possible settings for the temperature unit
Precondition Password access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Temperature unit line.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.1 General
Menu
Time format hh:mm:ssAM/PM
·········
Pressure unit psi
Unit of pressure
Temperature unit °F
Unit of temperature
·········
Display lighting
3. Press «Enter».
The display for the set unit flashes.
4. Use «Up» or «Down» to set the unit.
5. Press «Enter».
The setting is applied.
6. Press «Escape» repeatedly to return to the main menu.
8.2.11 Setting the display illumination
Set the display lighting mode:
Mode 1 2 3
Indication automatic on off
Function The illumination extin‐
guishes after the time-
out has elapsed.
Permanent setting
Illumination "on"
Permanent setting
Illumination "off"
Tab. 49 Display illumination
Precondition Access level 2 is activated.
1. Open the 5.1 <Configuration – General> menu.
2. Use «Up» or «Down» to select the Display lighting line.
8 Initial Start-up
8.2 Setting the controller
66
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE