KAESER SIGMA CONTROL 2 User Manual

6. Press «Enter».
The setting is applied.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.4.1 Compressor on
Menu
Local mode:
Key
Remote mode:
Key + remote contact
Active line
------------------------------
RC DI1.07 ok ☑
Result The machine start is set to Remote mode Key + remote contact .
8.5.3.2 Assigning another input
Inputs already assigned cannot be further assigned.
1. Use «Up» or «Down» to select the RC line.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.4.1 Compressor on
Menu
------------------------------
RC DI1.07 ok ☑
Remote contact DI 1.07 (default)
Logic : +
·········
Key remote : ☑
Key clock : ☐
2. Press «Enter».
The display for the currently set input flashes.
3. Select another input with the «Up» or «Down» keys.
4. Press «Enter».
The input has now been assigned.
5. Press the «Remote control» key to enable the machine to be started from the remote control
center.
If an input is rejected it means it is already assigned.
➤ Select a different input.
8.5.4 Activating the remote control
➤ Activating remote control, see chapter 8.2.13.
Result SIGMA CONTROL 2 remote control is activated.
8 Initial Start-up
8.5 Configuring machine start and stop
98
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet