KAESER SIGMA CONTROL 2 User Manual

Precondition Password access level 2 is activated
1. Open the menu 5.9 <Configuration – Refrigeration dryer> .
2. Using the «Up» or «Down» key, select the line Compressor ready: .
3. Press the «Down» key.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.9 Refrigeration dryer
Menu
Control mode
Compressor ready:
Continuous
Active line
Compressor Clk/RC/RB off:
off
·········
4. Press the «Enter» key.
The indicator flashes for the operating mode currently selected.
5. Using the «Up» or «Down» keys, set the operating mode Timer .
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.9 Refrigeration dryer
Menu
Control mode
Compressor ready:
Timer
Active line
Compressor Clk/RC/RB off:
off
·········
6. Press the «Enter» key.
The setting is applied accordingly.
7. Press the «Escape» key repeatedly to exit the menu.
Result The operating mode CONTINUOUS has been switched to TIMER.
8.8.2 Output messages
If required, you can activate messages regarding the operating temperature of the refrigerated dry‐
er as a binary signal.
You can assign to DOR or DOT .
If you have parametrized correctly, OK will be displayed.
Precondition Password access level 2 is activated.
1. Open the menu 5.9 <Configuration – Refrigeration dryer> .
8 Initial Start-up
8.8 Refrigerated dryer
110
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet